Wpa/Leap - Honeywell MX7 Reference Manual

WPA/LEAP

To use WPA/LEAP, make sure the following profile options are used.
Enter the SSID of the Access Point assigned to this profile
l
Set EAP Type to LEAP
l
Set Encryption to WPA TKIP
l
Set Auth Type as follows:
l
If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to
l
Open.
If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared.
l
If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.
l
To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for encryption and complete other entries as
detailed in this section.
See Sign-On vs. Stored Credentials for information on entering credentials.
7-33