Lamp Precautions - Christie Mirage 4K25 Setup Manual

Lamp precautions

Lamps used in the projector are under high pressure and must be handled with caution. Lamps can
explode and cause serious personal injury if dropped or mishandled.
Danger! Failure to comply with the following results in death or serious injury.
• Never attempt to access the lamp compartment while the lamp is on. Wait at least 10 minutes after
the lamp turns off before powering down, disconnecting from AC, and opening the lamp door.
• The arc lamp operates at a high pressure that increases with temperature. Failure to allow the lamp
to sufficiently cool before handling, increases the potential for an explosion causing personal injury
or property damage.
• Always wear manufacturer approved protective safety clothing (gloves, jacket, face shield) when
the lamp door is open or when handling the lamp. Only qualified technicians should install projector
lamps.
Warning! Failure to comply with the following could result in death or serious injury.
• Possibly hazardous optical radiation emitted from this product. (Risk group 3)
• Thermal radiation emitted from this product may cause burns. (Risk group 3)
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield,
i
protective gloves, and a quilted ballistic nylon jacket or a welder's jacket. This equipment is included
in included in the Christie Protective Clothing Safety kit
P/N: 598900-095.
Christie's protective clothing recommendations are subject to change. Any local or federal
specifications take precedence over Christie recommendations.
Mirage 4K25 Setup Guide
020-101362-02 Rev. 1 (01-2015)
Introduction
8