Introduction; Safety And Warning Guidelines - Christie Mirage 4K25 Setup Manual

Introduction

This manual is intended for professionally trained operators of Christie high-brightness projection
systems. These operators are qualified to replace the lamp and air filters, but should not attempt to
install or service the projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with
high-voltage, ultraviolet exposure, and the high temperatures generated by the projector lamp are
authorized to assemble, install, and service the projector.
For detailed installation, operation, maintenance, and troubleshooting information, refer to the
Mirage 4K25 User Manual (P/N:
documentation and technical support, go to www.christiedigital.com.

Safety and warning guidelines

This projector must be operated in an environment that meets the operating range specification.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in
the risk of fire, shock, or personal injury.
Warning! Failure to comply with the following could result in death or serious injury.
• Never look directly into the projector lens or at the lamp. The extremely high brightness can cause
permanent eye damage. For protection from ultraviolet radiation, keep all projector housings intact
during operation. Protective safety gear and safety goggles are recommended when servicing.
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated light
beam of the lamp.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
• The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters
of effective UV radiation. A workplace evaluation is advised to assure employees are not exposed to
cumulative radiation levels exceeding the government guidelines for your area. Be aware that
some medications are known to increase sensitivity to UV radiation.
NOTE: During maintenance and cleaning operations, the instructions define that the unit must not be
operational, thus the lamps are not active and there are no emissions. Optical adjustments are not
considered maintenance. The lamps are turned on during optical adjustments and emissions are
present.
Mirage 4K25 Setup Guide
020-101362-02 Rev. 1 (01-2015)
020-101361-XX). For complete Mirage 4K25 product
6