Removing The Power Supply; Replacing The Power Supply; Servicing A Magazine - Qualstar Q48 Installation And Operation Manual

Q24/Q48 Tape Library
5.7

Removing the power supply

1. Power down the library by pressing the power button on the front panel.
Adhere strictly to the following steps to remove a power supply:
2. Remove the power cord on the rear panel of the library.
3. Loosen the blue thumbscrews located on the rear of the power supply with your fingers.
4. Pull the power supply straight out of the library as shown below.
5. To store or ship the removed power supply, repackage it in the original or replacement device
packaging materials.
5.8

Replacing the power supply

Use this procedure to replace the power supply with another power supply:
1. Remove the power supply from the library, as described above.
2. To install the new power supply, see Section 2.11
5.9

Servicing a magazine

1. Unlock the appropriate magazine, using:
To remove a magazine, adhere to the following steps:
OCP, see Section 3.1.7
RMU, see Section 3.2.8.3
-
2. Emergency release, if you are not able to unlock the magazine with the OCP or RMU,
-
see Section 4.4
3. Pull the released magazine out of the library.
4. Remove all tape cartridges from the magazine.
5. To store or ship the removed magazine, repackage it in the replacement device packaging
materials.
6. Insert an appropriate magazine into the empty magazine slot of the library.
© Copyright QUALSTAR 2015
Figure 68 Remove the power supply
Installation and Operations Manual
90