Power-Down - Qualstar Q48 Installation And Operation Manual

Q24/Q48 Tape Library
Toggle values are used to switch between two different states like 'on' and 'off'. After navigating to the
Toggle values
menu item the display shows its current state. Pressing the <ENTER> button will select the item,
whose value may then be toggled using the <UP> and <DOWN> buttons. Pressing <ENTER> again sets
the item to the displayed value.
Numerical values are needed for network addresses, PIN entries, and other configuration entries. After
Numerical values
navigating to the menu item to be changed, the actual value will be displayed and the cursor stays on
the first digit. The value may be incremented / decremented with the <DOWN> and <UP> buttons.
After pressing the <ENTER> button to select the displayed value, the cursor moves to the next editable
digit. Each digit can be changed in the same way. After pressing the <ENTER> button at the last digit,
the complete entry will be stored. Pressing the <CANCEL> button will cancel the whole edit process
and the old value will be restored.
Pressing the Power button on the library while it is operational will initiate a controlled power down.
3.1.6

Power-Down

The following operations will take place before the unit shuts down completely:
The display indicates with an appropriate message that the shutdown is in progress.
The library controller finishes all ongoing loader and drive activities.
•
The media changer is moved to its home position.
•
The library controller switches off the power supply's secondary side.
•
•
NOTE
© Copyright QUALSTAR 2015
 The shutdown process may be aborted by pressing the cancel
button within the first 3 seconds.
Installation and Operations Manual
27