Ir Transmission Delay [Enabled]; Ur2 Duplex Mode [Normal]; Use Ir Pins [Ir-Rx2Tx2]; Onboard Parallel Port [378/Irq7] - IEI Technology IMBA-8650 User Manual

IMBA-8650 Motherboard

IR Transmission Delay [Enabled]

Use the IR Transmission Delay option to specify whether or not there should be a delay
for the IR transmission.
Enabled
Disabled

UR2 Duplex Mode [Normal]

Use the Parallel Port Mode option to select parallel port operation mode.
Half
Full

Use IR Pins [IR-Rx2Tx2]

Use the Use IR Pins option to select which pins should be used for infrared.
IR-Rx2Tx2 (Default)
RxD2,TxD2

Onboard Parallel Port [378/IRQ7]

Use the Onboard Parallel Port option to select the parallel port base address.
Disabled
378/IRQ7
278/IRQ5
(Default) There is a transmission delay.
There is no transmission delay.
Default Half-duplex mode allows transmission in one direction
at a time only.
Full-duplex mode allows transmission in both directions
at the same time.
No base address is assigned to the Parallel Port
D Parallel Port I/O port address is 378 and the interrupt
EFAULT
address is IRQ7
Parallel Port I/O port address is 278 and the interrupt
address is IRQ5
Page 147