Sata Drive Connection; Figure 5-10: Fdd Cable Connection - IEI Technology IMBA-8650 User Manual
Atx motherboard, intel pentium 4 processor with vga, dual sata, eight usb 2.0, sixcom, agp, five pci, two isa, gigabit ethernet and compactflash
Hide thumbs
Also See for IMBA-8650:
- User manual (239 pages) ,
- Quick installation manual (9 pages) ,
- Quick installation manual (8 pages)
Table of Contents
Advertisement
IMBA-8650 Motherboard
Figure 5-10: FDD Cable Connection
Step 3:
Connect the cable to an FDD device. Connect the connector at the other end
of the cable to an FDD device. Make sure that pin 1 on the cable corresponds to
pin 1 on the
5.6.6 SATA Drive Connection
The IMBA-8650 is shipped with SATA drive cables and SATA drive power cable. Follow
the steps below to connect the SATA drives to the motherboard.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown in
Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
connector.Step 0:
Figure 5-11.
Page 105
Advertisement
Chapters
Table of Contents
