Socket 478 Cooling Kit Installation; Figure 5-2: Cooling Kit Support Bracket - IEI Technology IMBA-8650 User Manual

IMBA-8650 Motherboard
properly aligned, the CPU should slide into the CPU socket smoothly
Step 6: Close the CPU socket. Re-engage the load lever by pushing it back to its
original position. Secure the load lever under the retention tab on the side of
CPU socket.Step 0:

5.3.2 Socket 478 Cooling Kit Installation

An IEI Socket 478 CPU cooling kit can be purchased separately. (See Section 3.3.2)
The cooling kit comprises a CPU heat sink and a cooling fan.
WARNING:
Do not wipe off (accidentally or otherwise) the layer of thermal paste on
the bottom of the heat sink. The thermal paste between the CPU and
the heat sink is important for optimum heat dissipation.
To install the cooling kit, please follow the steps below.
Step 1: Install the cooling kit bracket. A cooling kit bracket is installed on the rear of
the CPU card. Align the bracket with the four retention holes at the back of the
CPU card. Once properly aligned, insert four retention screws from the front of
the CPU card.

Figure 5-2: Cooling Kit Support Bracket

Page 93