Dual Rs-232 Cable With Slot Bracket; Figure 5-7: Ide Cable Connection - IEI Technology IMBA-8650 User Manual
Atx motherboard, intel pentium 4 processor with vga, dual sata, eight usb 2.0, sixcom, agp, five pci, two isa, gigabit ethernet and compactflash
Hide thumbs
Also See for IMBA-8650:
- User manual (239 pages) ,
- Quick installation manual (9 pages) ,
- Quick installation manual (8 pages)
Table of Contents
Advertisement
Figure 5-7: IDE Cable Connection
Step 3:
Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the
5.6.3 Dual RS-232 Cable with Slot Bracket
The dual RS-232 cable consists of two serial port connectors attached to a serial
communications cable that is then attached to two bracket mounted D-sub 9 male
connectors. To install the dual RS-232 cable, please follow the steps below.
Step 1:
Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2:
Insert the cable connector. Insert the connectors into the serial port box headers.
See Figure 5-8. A key on the front of the cable connectors ensures the
connectors can only be installed in one direction.
Page 102
IMBA-8650 Motherboard
connectorStep 0:
Advertisement
Chapters
Table of Contents
