Figure 5-9: Single RS-232 Cable Installation
Step 3:
Secure the bracket. The single RS-232 connector has one D-sub 9 male
connector secured to a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the
5.6.5 FDD Cable Connection
The FDD flat cable connects to the IMBA-8650 to one FDD device. To connect an FDD to
the IMBA-8650 please follow the instructions below.
Step 1:
Locate the FDD connector. The location of the FDD device connector is shown
in Chapter 3.
Step 2:
Insert the connector. Connect the FDD cable connector to the on-board
connector. See Figure 5-10. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Page 104
IMBA-8650 Motherboard
chassisStep 0: