Clear Cmos Jumper; Table 5-2: Cf Master/Slave Selection Settings - IEI Technology IMBA-8650 User Manual

The CF Master/Slave Selection jumper sets the CF Type I card or CF Type II cards as
either the slave device or the master device. CF Master/Slave Selection jumper settings
are shown in Table 5-2.
Pins Description
Open Slave
Short Master

Table 5-2: CF Master/Slave Selection Settings

5.4.2 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
If the IMBA-8650 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-3.
Pins Description
Page 98
Default
JP1
3-pin header
See Table 5-3
See Figure 5-6
IMBA-8650 Motherboard