Jumper Settings; Figure 5-4: Cf Card Installation; Figure 5-5: Jumper Locations - IEI Technology IMBA-8650 User Manual

IMBA-8650 Motherboard
socket pins are properly inserted into the socket. See Figure 5-4. Step 0:

Figure 5-4: CF Card Installation

5.4 Jumper Settings

NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the

Figure 5-5: Jumper Locations

plastic clip from a jumper.
Page 96