Top Standoffs; Locating The Fireplace - Town & Country Fireplaces TC36 Instruction Manual

Top Standoffs

The top standoffs are shipped loose inside the replace and must be installed on top of the replace (Figure 8).
Do this once the replace is in position.
TOP STANDOFFS
Figure 8: TC 36D Standoffs.

Locating The Fireplace

In planning the installation for the replace, it is necessary to determine where the unit is to be installed, location of vent
system and where gas supply piping may be plumbed. Various installations are possible, such as, into an existing wall, a
corner, a built-in wall or a wall projection (Figure 9). Due to high temperatures, do not locate this replace in areas of high
traffic or near furniture or draperies.
The minimum clearances from the fireplace to combustible surfaces must be adhered to and are shown in Figure 3 & Figure 4.
Figure 9: TC36 Possible locations.
5056.427D TC36_D & TC36_DAR_101215-52
8