Adjustable Lintel - Town & Country Fireplaces TC36 Instruction Manual

1. The adjustable lintel assembly
has two orientations for desired
nishing. A anged edge and a
hemmed edge. The lintel comes
factory installed with the ange
edge out. If the desired edge is
different from the factory setting,
use the following steps to change
the Lintel edge.
2. Remove safety barrier screen.
3. Remove the glass door trim
(Figure 24).
4. Loosen the securing bolts in the
upper and lower corners on each
side of the lintel and remove the
lintel. Rotate the assembly to
have the desired edge away from
the replace (Figure 25).
5. The lintel assembly can then be
adjusted to align ush with your
facing material by sliding in or out
approximately 1".
6. Tighten the securing bolts.
7. Reattach the window trim.
8. Reinstall safety screen.
TC36_D & TC36_DAR_101215-52

Adjustable Lintel

Figure 24:
SAFETY
BARRIER
TC 36D Lintel
SCREEN
and trim.
Figure 25: TC 36D Securing bolt.
15
GLASS FLANGED EDGE
DOOR TRIM
3/8 SECURING BOLT
5056.427D
HEMMED EDGE