Town & Country Fireplaces TC36 Instruction Manual page 40

Figure 64: Wall switch
interface side.
Figure 65: Wall switch
battery side.
Using the Remote Control Transmitter
Temperature indication Display (if thermostat function is enabled)
With the remote control transmitter in the "OFF" position, press the ther-
mostat and mode keys at the same time. Look at the LCD screen on the
remote control transmitter to verify that a C or F is visible to the right of the
room temperature display (Figure 68 or Figure 69).
Turn on the Fireplace
With the replace OFF, press the ON/OFF key on the remote control trans-
mitter. The remote control transmitter display will show the active icons on
the screen. At the same time the wall switch will activate the replace via
the IFC module. A single "beep" from the IFC module will con rm reception
of the command.
Turn off the Fireplace
With the replace ON, press the ON/OFF key on the remote control trans-
mitter. The remote control transmitter LCD display will only show the room
temperature (Figure 68 or Figure 69). At the same time the IFC module will
turn off the replace. A single "beep" from the IFC module con rms recep-
tion of the command.
Manual Bypass of the Remote Fireplace
If the batteries of the remote control transmitter are low or depleted, the
replace can be turned on and off manually using ON/OFF switch located on
Town & Country wall switch. This will bypass the remote control transmitter.
5056.427D
Program button
Figure 66: Town & Country
wall switch.
40
Figure 67: Pro ame 2 remote
battery bay.
Figure 68: Display in
fahrenheit.
Figure 69: Display in
celcius.
TC36_D & TC36_DAR_101215-52