Electrical - Town & Country Fireplaces TC36 Instruction Manual

The gas control system is located on the right hand side of the rebox behind
an access panel and the decorative rebox panel (if installed). The replace is
operated via a wall switch and a hand held remote control unit.
The wall switch is connected to the replace by a 40 ft. communication cable
supplied with the replace.
Installation
1. Place the replace in the desired location.
2. Remove the glass door frame from the replace.
3. Remove access panel from right hand side of the rebox (Figure 28).
4. Connect 110 V. AC electrical supply to the wires installed inside the junction
box (Figure 29). The replace is rated at 110 volts, 60Hz, 0.25A. The
optional power vent kit is rated at 115 volts, 60Hz, 1.8A.
The electrical wires can be accessed from both inside and outside the
junction box by removing one of the two small access panels (Figure 29) or
(Figure 30).
5. Attach the wall switch to the framing in the desired
location (40 ft is supplied with replace).
6. Route the wall switch control cable (supplied) as required to
the wall switch (Figure 32).
7. Attach one end of the wall switch control cable to the wall
control. (Figure 32), and the other end to the interface board
(Figure 30).
8. Insert the 4 supplied "AA" batteries into the battery pack
of the wall switch (Figure 33).
9. If not already installed, install the burner using
the instructions supplied with the burner kit.
10. Turn on the gas supply and check that all
connections are tight and leak free.
11. Turn on gas and electrical supplies.
12. Move the center button on the wall control (Figure 31)
to the "ON" position. The igniter will start to spark.
After a short delay, the pilot will light followed
by the main burner.
TC36_D & TC36_DAR_101215-52

Electrical

VACUUM
SWITCH
INSIDE ACCESS
PANEL
JUNCTION BOX GAS CONNECTOR
Figure 30: Valve assembly components.
17
FIREBOX ACCESS PANEL
Figure 28: Access to rebox.
JUNCTION BOX OUTER ACCESS PANEL
Figure 29: Junction box wiring.
TRANSFORMER
WALL SWITCH MODULE
CONNECTOR
5056.427D
REGULATOR
BOARD
POWER
VENT
SWITCH
(IFC) INTERFACE
BOARD