3. Apply gas connection before
installing panels.
4. Install the Right Side Panel by
inserting the bottom of the panel
in rst and then angling it up into
position. It may be necessary to
push the rebox shield up to allow
panel to move freely into place.
5. Install the Rear Upper Panel. Note
- the TC36 Arch has a one piece
rear panel.
6. Install the Left Side Panel by
inserting the bottom of the panel
in rst and then angling it up into
position.
7. Reinstall the Side Panel Retainers.
8. Install the Left and Right Front
Panels.
(HERRINGBONE PANEL SET SHOWN)
1. Place two smaller magnets on back of
each side rail.
2. Place two larger magnets on back of the
top and bottom rails.
3. Attach the side rails. Even the ends up
with the door frame.
4. Attach the top and bottom rails and
adjust so mitres are even at the corners.
TC36_D & TC36_DAR_101215-52
LEFT SIDE PANEL
Finishing Touch Trim Kit Instructions
Figure 61:
TC 36D & TC36D Arch trim.
REAR UPPER panel
REAR LOWER panel
FRONT LEFT PANEL
Figure 60: TC36D Panel placement.
35
FRONT RIGHT PANEL
RIGHT SIDE PANEL
5056.427D