Wiring Details - Shure DCS 6000 User Manual

Wiring Details

Main Power
Blue Neutral
Brown Live
Green/Yellow Earth (Ground)
DCS-LAN Chain
The DIS-CCU uses Cat5e, Cat6 or Cat7 F/UTP or U/FTP
cables with shielded RJ45 connectors.
EIA 568-B wiring must be used.
Important: The names of Cat5/6/7 cable type have
changed.
Old Name New Name
FTP F/UTP
STP U/FTP
UTP U/UTP
Important: Use only F/UTP or U/FTP (screened)
cables and screened RJ45 connectors and not U/UTP
cable, which is unscreened.
How to wire a Cat5e (EIA 568-B) cable to a RJ45 con.:
Pin Function Connector #1
1 In-going + ORG/WHT
2 In-going - ORG
3 +48V GRN/WHT
4 0V BLU
5 0V BLU/WHT
6 +48V GRN
7 Outgoing - BRN/WHT
8 Outgoing + BRN
If other color codes are used then the four pairs are
connected as follows:
Pair 2: Pin 1 & 2
Pair 3: Pin 3 & 6
Pair 1: Pin 4 & 5
Pair 4: Pin 7 & 8
The phase of the pairs must be correct and the wiring
specification EIA 568-B (Cat5e).
Cat6 and Cat7 cables are normally only be terminated
in sockets (female) and not in cable plugs.
Cat6 and Cat7 can only be used for feeding cables
terminating in wall outlets or patch panels.
Analog Audio Out
XLR3 male
Analog Audio In
XLR3 female
Emergency switch
Connector #2 Terminal block
ORG/WHT Connect the emergency switch to pin 1 and 2.
ORG
GRN/WHT
BLU
BLU/WHT
GRN
Earphones
BRN/WHT
3.5 mm Jack plug
BRN
68
Pin Signal
1 Earth
2 Signal +
3 Signal –
Pin Signal
1 Earth
2 Signal +
3 Signal –
Pin Connector Function
1 Tip Signal left
2 Ring Signal Right
3 Sleeve Electrical earth/screen
Cable type
2 x 0.25 mm2
shielded.
Cable type
2 x 0.25 mm2
shielded.