Analog Audio Outputs - Shure DCS 6000 User Manual

Analog Audio Outputs

Eight analog outputs are available for recording, language distribution system, teleconferencing unit, or an external PA
system.
A
Go to >
Audio Output Control
• Group: Eight separate groups for isolating specific microphones. This selection corresponds to the groups configured
from the page.
Group Setup
Note: If the group buss is not used for the corresponding XLR output, it is unavailable in the routing matrix.
• Ch. 1 -31: Interpretation channels
• Floor: The audio from all open microphones that are routed to Group A (floor mix). There are three variations on this
mix to chose from:
• Ch. 0: Headphone mix with AGC, useful for sending to an IR language distribution system.
• Floor 1: Loudspeaker mix, useful for sending to a PA or broadcast equipment.
• Floor 2: Loudspeaker mix with volume attenuation (
TCP/IP
B C D Out A Out B
Select the audio source for each analog output
and choose from the following options:
Audio
Out C Out D Out E Out F Out G Out H
Eight Analog Outputs
> )
Loudspeaker Control
42
DIS-CCU