Connection Details - Shure DDS 5900 User Manual

12.5 Connection Details

Main Power
Blue Neutral
Brown Live
Green/Yellow Earth (Ground)
Chain (DCS-LAN)
The DDS 5900 system uses Cat5e, Cat6 or Cat7 F/UTP or
U/FTP cables with screened RJ45 connectors.
EIA 568-B wiring must be used.
Important: The names of Cat5/6/7 cable type have
changed.
Old Name New Name
FTP F/UTP
STP U/FTP
UTP U/UTP
Important: Use only F/UTP or U/FTP (screened)
cables and screened RJ45 connectors and not U/
UTP cable, which is unscreened.
How to wire a Cat5e (EIA 568-B) cable to a RJ45 con.:
Pin Function Connector #1
1 In-going + ORG/WHT
2 In-going - ORG
3 +48V GRN/WHT
4 0V BLU
5 0V BLU/WHT
6 +48V GRN
7 Outgoing - BRN/WHT
8 Outgoing + BRN
If other color codes are used then the four pairs are
connected as follows:
Pair 2: Pin 1 & 2
Pair 3: Pin 3 & 6
Pair 1: Pin 4 & 5
Pair 4: Pin 7 & 8
The phase of the pairs must be correct and the wiring
spec. as stated in Cat5e (EIA 568-B) has to be followed.
Cat6 and Cat7 cables are normally only be
terminated in sockets (female) and not in cable plugs.
Cat6 and Cat7 can only be used for feeding cables
terminating in wall outlets or patch panels.
Analog Audio Out
XLR3 male
Pin Signal
1 Earth
2 Signal +
3 Signal –
Connector #2
ORG/WHT
ORG
GRN/WHT
BLU
BLU/WHT
GRN
BRN/WHT
BRN
Cable type
2 x 0.25 mm2 shielded.
Analog Audio In
XLR3 female
Pin Signal
1 Earth
2 Signal +
3 Signal –
Emergency switch
Terminal block
Connect the emergency switch to pin 1 and 2.
Earphones
3.5 mm Jack plug
Pin Connector
1 Tip
2 Ring
3 Sleeve
Cable type
2 x 0.25 mm2 shielded.
Function
Signal left
Signal Right
Electrical earth/screen