Installing Large Systems - Shure DCS 6000 User Manual

Installing Large Systems

Power Supplies for Additional Components
To add additional components to the system, add an inline or rackmount power supply to the microphone unit chain.
Multiple power supplies can be used to reach the maximum 3,800 supported units.
Note: To exceed 250 units, make sure the FL6000-3800 license has been purchased and installed in the CCU.
Inline Power Supply
Use the PI-6000 power inserter to add an inline power supply for up to 50 more microphone units. The unit may be
connected at any point in the chain to power the additional components.
Note: The PI-6000 does not refresh the data signal, so total cable length cannot exceed 200 m before a repeater.
Central Control Unit PI-6000 Power Inserter
~50 conference units ~50 additional units
Inline Power Supply (1x)
Rackmount Power Supply for 4 Additional Chains
Use the EX 6010 rackmount extension unit to add additional components and configuration options. The unit expands
the DCS chain into 4 separate outputs, each with a power supply equivalent of a CCU (up to 50 units).
Note: The EX 6010 also refreshes the data signal, enabling an additional 200 m of cable from each port.
Central Control Unit EX 6010 Extension Unit
~50 units from each port
Rackmount Power Supply (x4)
27