Sensor (2Nd Scan) Static Jam Service Check; Sensor (2Nd Scan) Lingering Jam Service Check - Lexmark X651de Service Manual

Sensor (2nd scan) static jam service check

Use this procedure for the following jams:
• 291.00
1 Check the media path.
Is the media path free of media or media fragments?
2
Check the sensor (2nd scan) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch Observe the line "sensor (ADF 2nd scan)
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
3 Check the sensor (ADF 2nd scan) for proper connection.
Is the above component properly connected?
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
5
Perform a print test using the ADF.
Does the problem remain?

Sensor (2nd scan) lingering jam service check

Use this procedure for the following jams:
• 291.01
Step
1 Check the media size setup and tray guides for the ADF.
Does the media size, in use, match the size set for the ADF
Check
Go to step 2. Remove any
media or media
fragments.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (ADF 2nd connection.
scan).
Go to "Sensor
(ADF 2nd scan)
removal (models
X651, X652,
X654, X656, and
X658)" on
page 4-78.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
removal (models
X651, X652,
X654, X656, and
X658)" on
page 4-65.
Go to step 5.
Contact next Problem solved.
highest level of
tech support.
Yes
Go to step 2. Replace the
media, or change
the media size
setup.
Diagnostic information
7462
No
2-127