7462
Offset stacker tamper drive motor assembly removal
1. Remove the offset stacker top cover. See
2. Pull slack in the tamper drive belt and remove the belt from the tamper drive belt pulley.
3. Disconnect the tamper driver motor harness from the controller card.
4. Remove the two screws (A) securing the tamper drive motor assembly to the tamper frame.
5. Remove the tamper drive motor assembly.
Offset stacker media stack flap and media stack flap actuator removal
1. Remove the offset stacker handle cover. See
2. Release the locking tab and slide the media stack flap actuator to the right and remove..
4-236
Service Manual
"Offset stacker top cover removal" on page
A
"Offset stacker handle cover removal" on page
4-230.
4-231.