Skew (Using Adf) - Lexmark X651de Service Manual

Skew (using ADF)

Leading edge
Trailing edge
The printed image is not paralleled with both sides of the media.
Step
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
2
Properly load document into the ADF unit assembly and
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
3 Check for obstructions in the area of the media feed
path in the ADF.
Is the media feed path free from any obstructions?
4
Is the ADF left cover assembly properly and evenly
closed.
5 Check the ADF/pick roll assembly for damage and
wear.
Is the ADF feed/pick roll assembly free from damage
and wear?
6 Check the ADF separator roll.
Is the ADF separator roll free from damage and wear?
Check Yes
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem solved.
Go to step 4. Remove
obstructions.
Go to step 5. Open then
properly close
the ADF left
cover assembly.
Go to step 6. Replace the
ADF feed/pick
roll assembly.
Go to
feed / pick roll
assembly
removal
(models X651,
X652, X654,
X656, and
X658)" on
page
Go to step 7. Replace the
ADF separation
roll.
Go to
separator roll
removal" on
page
Diagnostic information
7462
No
"ADF
4-59.
"ADF
4-60.
2-189