Connecting to power
The Easypix Power is supplied with an IEC power cable ready for
connection to a single-phase 3-wire (live, neutral, ground/earth) power
distribution system at 100-120/200-240 VAC nominal, 50/60 Hz.
Details of standard US and EU conductor identification systems are
given in Table 1.
Important! Check that all installation work is completed and carry
out appropriate tests and safety checks before applying power.
If you decide to fit the supplied power cable tail with a plug that is
suitable for your AC mains power outlets, install a grounding-type
(earthed) plug that is rated 5 A minimum, following the plug
Table 1 shows some possible pin identification schemes; if pins are not
clearly identified, or if you have any doubts about proper installation,
consult a qualified electrician.
Table 1: Conductor identification
Easypix user manual