Martin Easypix 300 User Manual page 13

To mount the luminaire on a surface using 35 mm DIN rail:
1. Fasten the DIN rail securely to the mounting surface.
2. See Figure 2. The luminaire mounting bracket has a hooked profile
on one side (see A). Hook this profile over the top of the DIN rail
and swing the bracket down. Use a 2.5 mm Allen key to tighten the
mounting clamp screw (see B).
Mounting the Easypix luminaire vertically
The mounting clamp screws will not hold the product securely on the
DIN rail if luminaire is installed vertically. You must therefore insert
screws in the mounting surface through the DIN rail mounting holes
(see Figure 3) so that the luminaire mounting clamps rest against these
screws and secure the luminaire.
Figure 2: Mounting on DIN rail
13