Connecting To Power; Installing A Temporary Power Plug; Data Connections - Martin Exterior Wash Pro QUAD XL Safety And Installation Manual

Connecting to power

The fixture is supplied with a 2 m (6.5 ft.) power cable tail installed ready for connection. See
illustration below:
To connect to a single-phase system or to one phase of a three-phase, four-wire system:
1. Lock out power to the installation.
2. Connect the conductors in the power cable to the distribution circuit inside a sealed junction box
as follows:
•
Connect the green wire (US models) or yellow/green wire (EU models) to ground (earth).
•
Connect the white wire (US models) or blue wire (EU models) to neutral.
•
Connect the black wire (US models) or brown wire (EU models) to live (one phase).
3. Check that all installation work is completed and carry out appropriate tests and safety checks
before applying power.

Installing a temporary power plug

If you install a power plug on the power cable for temporary use, install a grounding type (earthed)
plug with integral cable grip that is rated minimum 277 V, 6 A. Follow the plug manufacturer's
instructions and connect the wires in the power cable as shown in the following table:
US system
EU system

Data connections

See the Exterior Wash Pro User Manual available for download from www.martin.com for details of
connecting the fixture to control data.
Use shielded, twisted-pair, high-quality dedicated DMX cable only for the control data link. Microphone
cable is not suitable.
®
Martin Exterior Wash Pro family Safety and Installation Manual Rev. A
AC power cable details
Live or L Neutral or N
Black White
Brown Blue
Power plug connections
Earth, Ground or
Green
Yellow/green
17