Hitachi WJ200-001S Quick Reference Manual page 38

Two Stage Acceleration and Deceleration
When terminal [2CH] is turned ON, the inverter
changes the
deceleration from the initial settings
) to use the second set of acceleration/
deceleration values. When the terminal is
turned OFF, the inverter is returned to the
original acceleration and deceleration time
( acceleration
deceleration time 1). Use

time 2) and
the second stage acceleration and deceleration
times.
In the graph shown above, the [2CH] becomes active during the initial acceleration. This
causes the inverter to switch from using acceleration 1 () to acceleration 2 ().
Option Terminal
Code Symbol

2CH
Valid for inputs:
Required settings
Notes:
 Function

selects the method for second
stage acceleration. It must be set =
the input terminal method in order for the [2CH]
terminal assignment to operate.
rate of acceleration
time 1,

(deceleration time 2) to set
Function Name
Two-stage Accelera-
tion and
Deceleration
~
, , =

to select
and
( and
Output
frequency
[2CH]

and
(acceleration
[FW,RV]
State
ON Frequency output uses 2nd-stage acceleration and
deceleration values
OFF Frequency output uses the initial acceleration 1 and
deceleration 1 values
Example (default input configuration shown see
page 69):
7
See I/O specs on
36
second
initial
1
0
1
0
Description
2CH
6 5 4 3 2 1
page 24, 25.
Target
frequency
t
L P24
PLC