Hitachi WJ200-001S Quick Reference Manual page 63

Fine Tuning Functions
Func.
Name
Code

Restart mode on power failure
/ under-voltage trip
 Allowable under-voltage power
failure time
 Retry wait time before motor
restart

Instantaneous power failure /
under-voltage trip alarm
enable

Number of restarts on power
failure / under-voltage trip
events

Restart frequency threshold

Restart mode on over voltage /
over current trip

Number of retry on over
voltage / over current trip
 Retry wait time on over voltage
/ over current trip
"b" Function
Description
Select inverter restart method,
Five option codes:
Alarm output after trip, no
automatic restart
Restart at 0Hz
Resume
frequency matching
Resume previous freq. after
freq. matching, then decelerate
to stop and display trip info

Resume operation after active
freq. matching
The amount of time a power input
under-voltage can occur without
tripping the power failure alarm.
Range is 0.3 to 25 sec. If
under-voltage exists longer than this
time, the inverter trips, even if the
restart mode is selected.
Time delay after under-voltage
condition goes away, before the
inverter runs motor again.
Range is 0.3 to 100 seconds.
Three option codes:
Disable
Enable
Disable during stop and
decelerates to a stop
Two option codes:
Restart 16 times
Always restart
Restart the motor from 0Hz if the
frequency becomes less than this
set value during the motor is
coasting, range is 0 to
*1
400(1000) Hz
Select inverter restart method,
Five option codes:
Alarm output after trip, no
automatic restart
Restart at 0Hz
Resume
frequency matching
Resume previous freq. after
active freq. matching, then
decelerate to stop and display
trip info
Resume operation after active
freq. matching
Range is 1 to 3 times
Range is 0.3 to 100 sec.
61
Run
Mode
Edit

operation after






operation after


Defaults
Initial data Units

00
1.0 sec.
1.0 sec.

00

00
0.00 Hz

00
3 times
1.0 sec