Hitachi WJ200-001S Quick Reference Manual page 27

Terminal Name
O
H
SP, SN
AL0, AL1, AL2 *3
Note 1: The two terminals [L] are electrically connected together inside the inverter.
Note 2: We recommend using [L] logic GND (to the right) for logic input circuits and [L]
analog GND (to the left) for analog I/O circuits.
Note 3: Refer to page 42 for details of trip signals.
Refer to page 96, "Functional safety" for details
Note 4:
Wiring sample of control logic terminal (Source logic)
SN 7/EB
SP EO EA
Note: If relay is connected to intelligent output, install a diode across the relay coil
(reverse-biased) in order to suppress the turn-off spike.
Caution for intelligent terminals setting
In turning on power when the input to the intelligent terminals becomes the following operations,
the set data might be initialized.
Please ensure not becoming the following operations, in changing the function allocation of the
intelligent input terminal.
1) Turning on power while [Intelligent input terminal 1/2/3 are ON] and [Intelligent input
terminal 4/5/6/7 are OFF].
2) After 1)'s condition, turning off power.
3) After 2)'s condition, turning on power while [Intelligent input terminal 2/3/4 are ON]
and [Intelligent input terminal 1/5/6/7 are OFF].
Description
Analog voltage input
+10V analog reference
Serial communication terminal
Relay common contact
6 5/PTC 4/GS2 3/GS1
H O OI
Variable resistor
for freq. setting
(1k-2k)
0 to 9.8 VDC range, 10 VDC nominal,
input impedance 10 k
10VDC nominal, 10mA max.
For RS485 Modbus communication.
250VAC,
250VAC,
100VAC,
30VDC,
30VDC,
5VDC, 100mA min.
Jumper wire
(source logic)
1 L
2
L AM CM2
Freq. meter
25
Ratings
2.5A (R load) max.
0.2A (I load, P.F.=0.4) max.
10mA min.
3.0A (R load) max.
0.7A (I load, P.F.=0.4) max.
PLC P24
12 11/EDM
RY RY