Blow Function Setting - Daikin RY24PEV1K Service Manual

SiK401004_A

3.4.12 Blow Function Setting

Blow function: After the unit is turned off, water in evaporator of indoor unit will be
In cooling and dry mode, press Function button till the unit enters blow function, BLOW
blinking, and then press Enter/Cancel button to turn on this function.
In blow mode, press Function button till the unit enters BLOW function and then press
Enter/Cancel button to cancel this function.
BLOW function setting is shown in Fig.3.4.12
Note:
1.After setting BLOW function, turn off the unit by pressing On/Off button on remote
2.There is not BLOW function in fan or heating mode.
FUNCTION CONTROL
automatically evaporated to avoid mildew.
controller, indoor fan will run at low fan speed for 10 min. (BLOW shows). Meanwhile, if
BLOW function is canceled indoor fan will be turned off directly.
Fig.3.4.12 Blow function setting
52