Table of Contents
Advertisement
8.5. Attaching Stand-Off Spacers
8.5.1. For President FS only
These spacers need not be fitted if the rear of the appliance is more than 1
from any combustible material and if the installer can be absolutely certain that no
combustible construction will be added at a future date – consult with the owner.
!Warning: Failure to install the stand-off spacers unless the above conditions can be
assured may result in a fire hazard.
1.
Remove the two screws at each of the rear top corners of the appliance. See figure
42.
2.
Fit the two wall spacers (Supplied with #530 Engine unit) using the screws just
removed. See figure 41.
8.5.2. For ZC Models only
The stand-off spacers for these installations are supplied flat with the Zero
Clearance case. These spacers are left and right handed.
!Warning: Failure to install the stand-off spacers may result in a fire
hazard.
1.
Remove the two screws near each of the rear top corners of the
appliance and the two screws near the rear top of each side.
2.
Bend the spacers as shown in figure 42.
3.
Screw the spacers to the rear of the appliance using the screws just
removed. See figure 42.
4.
Bend the side wings of the spacers to align the two holes in each spacer
with those in the appliance sides. secure the spacers using the screws just
removed. See figure 42.
8.6. Attaching Plinth & Rear Support – President ZC
1.
Detach the burner module by removing 11 screws. See figure 43.
2.
Fit the rear support channel under the rear of the appliance attaching it
to the appliance back panel with two
screws – see figure 44.
3.
Fit the front plinth under the appliance front with two thread forming
screws – See figure 45.
Figure 44
1
/
3 /
" thread cutting (pointed end)
8
26
" (32mm)
4
Figure 41
Figure 42
Figure 43
Figure 45
Advertisement
Table of Contents
