Stand-Offs - Valor H4 650JN Installation Manual

Appliance Preparation
Install Top Stand-off
1. Remove two screws from the rear of the appliance's
frame top.
2. Bent the 12-inch stand-off and secure it to the ap-
pliance case with the two screws just removed as
indicated.
12-inch stand-off supplied fl at
Install Support Angles
The distance from the support angles to the front face
of the appliance case is adjustable to allow for a range
of wall fi nish material thickness (e.g. tile, etc.).
1. Check the wall fi nish requirements with the home-
owner.
2. Secure the side support angles from the inside of
the appliance using two screws provided on each
side. Set back the support angles from the front of
the appliance by the thickness of the wall fi nish +
3/4" (19 mm) for projection.
Remove Rear Log Support
Remove the rear log support to access to the rear
orifi ces for restrictors installation (5 screws).
24
Thickness of wall finish + extra 3/4" (19 mm)
(Appliance MUST project 3/4" (19 mm) in front
of the wall finish surface)
Fit screws
from inside
case
Stand-off and Support angles install
Remove rear support

Stand-offs

Fix to appliance
case with
two screws