Attaching Stand-Off Spacers; Attaching Plinth & Rear Support - President Zc & Impression Zc - Valor 530 Direct Vent Installation Manual

Attaching Stand-Off Spacers

8.6.1. For President FS only
These spacers need not be fitted if the rear of the appliance is more than 1
(32mm) from any combustible material and if the installer can be absolutely certain
that no combustible construction will be added at a future date – consult with the
owner.
!Warning: Failure to install the stand-off spacers unless the above conditions
can be assured may result in a fire hazard.
1. Remove the two screws at each of the rear top corners of the appliance. See
figure 42.
2. Fit the two wall spacers (Supplied with #530EAN Engine unit) using the
screws just removed. See figure 42.
8.6.2. For ZC Models only
The stand-off spacers for these installations are supplied flat with the
Zero Clearance case. These spacers are left and right handed.
!Warning: Failure to install the stand-off spacers may result in a
fire hazard.
1. Remove the two screws near each of the rear top corners of the
appliance and the two screws near the rear top of each side.
2. Bend the spacers as shown in figure 43.
3. Screw the spacers to the rear of the appliance using the screws
just removed. See figure 43.
4. Bend the side wings of the spacers to align the two holes in each
spacer with those in the appliance sides. secure the spacers using the
screws just removed. See figure 43.
8.7. Attaching Plinth & Rear Support – President ZC
& Impression ZC
8.7.1. Detach The Burner Module
1. Detach the battery shield by removing two screws. See figure 44.
2. Detach the burner module by removing 11 screws. See figure
44.#
8.7.2. Fit The Rear Support
Fit the rear support channel under the rear of the appliance attaching it to
the appliance back panel with
3 /
two " thread cutting
8
(pointed end) screws – see
figure 45.
Figure 45
Manufactured by Miles Industries Ltd., British Columbia, Canada
1
/ "
4
Figure 43
Figure 44
Figure 46
25
Figure 42