Table of Contents
Advertisement
18.2. Cleaning
1.
It will be necessary to clean the glass periodically. During startup, condensation,
which is normal, forms on the inside of the glass and causes dust, lint etc. to cling to the
glass surface. Initially paint, while curing, may deposit a slight film on the glass. We
therefore recommend that, during the first few weeks of use, the glass is cleaned two or
three times with non-abrasive common household cleaners and warm water. Ammonia
based cleaners should not be used. Subsequently the glass should be cleaned two or three
times a season depending on the circumstances. Do not clean the glass while it is hot.
2.
Dust, etc. can be brushed from the ceramic fuel effects and firebox walls after
removing the front unit and opening the window.
Removing the front unit
•
President FS: Remove top & unhook front unit – See figure 83
•
President ZC: Unhook the front unit. Lift the front by holding the decorative grille.
Don't lift by holding the top. See figure 84.
Opening the window (See figure 85)
Always securely replace the window before lighting.
The inside of the window can be cleaned by pulling forward and rotating the two
clamping bars at the top corners of the window and swinging the window part way down.
! Be careful not to distort or damage the spring loaded bolts – Don't swing the
window down more than is necessary!
To completely remove the window, also unscrew the two spring loaded bolts at the
bottom of the window. After refitting the window apply light hand pressure against the
window frame sides to bed in the window seal.
3.
Dust etc. can also be removed from the burner using a soft brush after removing the
ceramic fuel effects. Always completely remove the window before removing the
ceramic fuel effects.
When cleaning, make sure that no particles are brushed into the slots in the burner.
Figure 85
42
Figure 83
Figure 84
Advertisement
Table of Contents
