Inspire M1 Assembly & Operation Manual page 23

33 17
Step 17
A Slide the C shaped Shroud Bracket into the pocket at one end of Shroud. (Pocket
seam should face the inside). Work the shroud around the bracket until the
opening in the back of the shroud lines up with the hole on the back of the bracket.
Repeat this on the opposite end of the shroud.
B Now position the shroud assembly around the upper and lower Shroud Mount Plates
by working around the guide rods and stack. Align the holes at the top and bottom
brackets with the holes in the plates and insert T-Pins (33) in each hole (3 on top and
3 on bottom).
C Secure the Top Shroud Plate (17) using the 2-M10x100 Shroud Tensioning Bolts on
the Top Beam Assembly (16). Stretch the shroud tight by threading the bolts at the
top. Work between the 2 bolts to adjust each side evenly.
32
29
PAGE 20
2-M10x100
Hex Bolts