Inspire M1 Assembly & Operation Manual page 13

Step 7
DO NOT TIGHTEN ANY HARDWARE IN THIS STEP
A Slide the Weight Stack Risers (7), Rubber Donuts (6), and 15 Weight Plates (5) onto
the Guide Rods (3). Make sure the weight sticker cut out is facing the front of the
machine. If a 200 lb stack will be used then the Weight Stack Risers (7) must be
removed.
B Screw the Top Weight Pulley Bracket Assembly (8) onto the Selector Stem at the Top
Weight (4). Thread all the way down but do not tighten yet. Slide the Top Weight
Assembly (4) onto the Guide Rods (3) so the 3-1/2" pulley is positioned between the
two Guide Rods (3).
C Insert a Weight Pin (10) into the stack.
D Attach weight stack stickers.
NOTE: Verify that the 2 pin holes at the front of the Top Shroud Plate (17) are facing the
front of the machine and that the single hole is facing the back of the unit.
3
PAGE 10
17
8
9
4
5
6
7
10