Inspire M1 Assembly & Operation Manual page 12

Step 6
DO NOT TIGHTEN ANY HARDWARE IN THIS STEP
A Attach Guide Rods (3) to the Main Base (1) using 2- M10x45 Sock Head Screws
(XX), 4- M10 Washers (62), and 2- M10 Lock Nuts (65).
B Slide the Bottom Shroud Plate (2) onto the Guide Rods (3) and use 2- M10x55
Hex bolts (49), 4- M10 Washers (62), and 2- M10 Lock Nuts (65) to secure the
shroud plate.
NOTE: Verify that the 2 pin holes at the front of the Bottom Shroud Plate (2) are
facing the front of the machine and that the single hole is facing the back of the unit.
3
2-M10x55 Hex Bolts
4-M10 Flat Washers
2-M10 Lock Nuts
2
1
PAGE 9
2-M10x45 Socket Head Screw
4-M10 Flat Washers
2-M10 Lock Nuts