Setting Up; Attaching The Lens; Projection Method - Christie LX1750 User Manual

Hide thumbs Also See for LX1750:

Table of Contents

Available languages

Setting up

Before putting the projector in position, attach the lens to the projector body.

First, determine the correct lens for the environment in which you are going to use the projector.

For lens product numbers and lens specifications suitable for the projector, consult your dealer. When attaching

or replacing a lens, consult the technical staff or service personnel at a specialist dealer for safety. Do not attempt

to attach or replace the lens by yourself. For details, refer to "Notes on attaching the lens" (

When setting up the projector after installing a lens, always fit the lens cover to the lens. When carrying or

holding the projector body, never hold the lens. Doing so may damage the projector.

You can project images vertically and diagonally. You can select rear (

menu. Select the projection method appropriate to the environment.

■ Mounting on the ceiling and

projecting forward

■ Mounting on the ceiling and

projecting from rear

(Using the translucent screen)

z To get a high picture quality, set up the screen in a location that is, as far as possible, not directly affected by

natural light or electric light. Draw the curtains or blinds and turn off the lights.

z When setting up the projector with tilt, do not use the projector at an inclination angle that exceeds ±10°

vertically to the horizontal plane. Installing the projector at an inclination angle that exceeds this value may

reduce the component life and result in malfunctions.

24 - ENGLISH

page 58) and ceiling (

■ Setting on a desk/floor and

projecting from rear

(Using the translucent screen)

■ Setting on a desk/floor and

projecting forward

page 58) from the

LX1750 User Manual

020-000638-01 Rev.1 (11-2013)

Table of Contents