Using The Remote Control; Inserting And Removing The Batteries; Setting Remote Control Numbers; Using The Remote Control As A Wired Remote Control - Christie LX1750 User Manual

Using the remote control

Inserting and removing the batteries

1) Open the cover.
(i)

Setting remote control numbers

When you are using multiple projectors, you can set a remote control number to each projector to allow
simultaneous control with a single remote control.
After setting a remote control number of a given projector, specify that projector using the remote control number.
■ Setting method z
1) While holding the <MENU> button, press the number (<0> - <9>) buttons (2 digits) to
enter the desired remote control number.
z
z When you release the button, the remote control number will change to the new number.
z
z To set the remote control number to 09, press <0>, <9> while holding down the <MENU> button.
Note
z The factory default setting is [All]. [All] supports all remote control numbers.
z Set the remote control number of the projector using [Remote control] from the [Setting] menu (
z To reset the remote control number (to set to [All]), simultaneously hold down the <MENU> button and the
<0> button for at least five seconds.

Using the remote control as a wired remote control

Connect the <R/C JACK> terminal on the projector body to the wired remote control terminal on the remote
control using the remote control cable (commercially available).
z Make sure that the batteries are inserted in the remote control.
z To use the remote control wirelessly, disconnect the remote control cable from the projector and the remote
control. When the remote control cable is connected, you cannot use the remote control wirelessly.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
(ii)
Using the remote control
2) Insert the batteries and close the
cover.
z
z Insert the side first.
z
z To remove the batteries, follow the above
procedure in reverse.
page 67).

ENGLISH - 23