Christie LX1000 Replacement Instruction Sheet

INTRODUCTION
These instructions outline the details for Lamp and Filter replacement in the LX1000 projector (Model
No. 103-021104-01). NOTICE: Use only a Christie approved Lamp and Filter Kit for your specific
projector model.
KITS REQUIRED
003-120479-01 (Replacement Lamp)
003-002003-01 (Replacement Air Filter)
INSTRUCTIONS
LAMP REPLACEMENT
When the projection lamp reaches its end of life, the Lamp
replacement icon appears on the screen and the LAMP 1/ REPLACE
or LAMP 2/REPLACE indicator is orange. Replace the lamp with a
new one promptly. The timing for illumination of the lamp
replacement indicator depends on the lamp mode.
minutes before the lamp cover is opened. The inside of the
projector can become very hot and may cause injury.
NOTICES: 1) Switch the lamp OFF before opening the lamp cover. 2) For continued safety, replace
with a lamp assembly of the same type. 3) Do not drop the lamp assembly or touch a glass bulb! The
glass can shatter and may cause injury.
NOTE: The Lamp replacement icon will not appear when the Display function is set to "Off", or
during "Freeze".
LX1000 Lamp/Filter Replacement Instruction Sheet
020-000168-01 Rev. 1 (02-2009)
LX1000 Lamp/Filter Replacement
Allow the projector to cool for at least 45
Instruction Sheet
1 of 4