Door Access Mode; Alarm Setting; Composition Of Alarm; Basic Configuration Of The Alarm - EverFocus EFC301FR User Manual

Table of Contents

4.7.3 Door Access Mode

Select "Door Entry Mode" or "Door Exit Mode" menu item and press "#" to enter the

submenu. Select the desired mode and press the numerical key "5" to select. The selected

item is marked with a "*". Then, press"*" or"#" to exit the current interface.

The EFC301F controller provides 1 fire alarm input, 4 alarm inputs and 2 alarm outputs.

Users can carry out detailed configurations through the user interface. Details will be

introduced below.

The alarm input of the EFC301F controller can be connected with external alarm equipment

such as a PIR sensor, glass breakage sensor, etc and the alarm output can drive a 4A alarm

relay.

The EFC301F controller will record all events such as entry permit, entry prohibition, etc.

Some dangerous events are required to trigger alarm output, such as fire alarm input,

protection area alarm input, etc. Some events do not need alarm output, such as card

swiping operations at invalid times. Whether the alarm is required to be triggered will be

set according to the user's requirement. EFC301F collects all the event records that may

trigger alarm output and makes effective or ineffective alarm choices of these events.

All major events can be set to trigger alarms, such as alarm input signals, unknown cards,

expired cards, invalid cards, invalid door regions, invalid times, anti-passback failure, wrong

password, wrong system password, wrong protection setup/withdrawal password, forced

door open, Door Over Time and remote alarm. The detailed setup method will be

introduced below.

Door Entry Mode

Door Exit Mode

Follow schedule

*Card Only

Card + PIN

Card or PIN

TCP/IP Network Access Controller

Normal Close

Normal Open

Table of Contents

Efc301fm