Address Setting - EverFocus EFC301FR User Manual

Step 3: In case of an alarm, the alarm output will last for a period of time, which is called
the alarm time. When the alarm exceeds this period of time, the alarm will be automatically
cleared (except for fire alarm, which can only be manually reset).The default alarm time is 1
min. After inputting the alarm time, press "#" to save the current setting. The system will
return to the submenu of the "Alarm Setting."
4.8.4.3 Alarm Action Setting
The Alarm Setting can set the alarm with physical input, as well as the alarm output time of
illegal events, such as the unknown card, invalid card, expired card, invalid time, invalid door
region, etc.
In the submenu of the "Alarm Setting," select the "Alarm Action Setting" menu item and
press "#" to enter the submenu to set the alarm output time. The submenu has 13 menu
items. Select the corresponding alarm events and Alarm Action Setting for the
corresponding events.
For example, in case of setting the SYS PIN Fail, in the submenu, select "SYS PIN Fail" menu
item and press "#" to enter the alarm time setting interface. All the outputs of alarm events
are latched modes and their settings are similar to the physical alarm input time setting.
The setting steps of other alarm events are the same as those of the SYS PIN Fail Setting.

4.9 Address Setting

Each device connected to the same RS485 bus must have a unique address for the purpose
of communications and control. When multiple controllers connect to PC via an RS485 bus,
each controller must be assigned a distinct address.
SYS P IN F ail
ARM PIN Fail
Remote Alarm Out
Unknown Card
Card Pin Fail
Forced Open Alarm
Held Open Alarm
Reader Lost Alarm
SYS PIN Fail
Alarm Port： 1 2
Y N
Cancel Next
TCP/IP Network Access Controller
Expire Card Alarm
Invalid Card Alarm
Invalid Time Alarm
ABP Fail Alarm
Panic Open Alarm
Panic Open Alarm
Alarm Time
000 Min 10 Sec
Cancel OK
39