Table of Contents
Advertisement
The default password of the system is 00000000. After entering the alarm administration
password, press "#." If an incorrect password is entered three consecutive times, the system
will automatically sound the alarm and lock the keyboard for 1 min. For security purposes, it
is suggested that the user change the password after entering the system for the first time
and properly secure the password.
After the protection setup administration authority is successfully verified, enter the
protection setup administration system. If there currently is an alarm input or latched alarm
input, the system will request to reset the alarm. The system will prompt the user to press
"#" to reset the alarm system,
operation,
press
withdrawal and press "*" to exit and save the settings on exit. If carrying out protection
setup operation of the system, after exit, the system will enter protection setup delaying
state.
Under the protection setup operation mode, the Alarm In LED lamp 1-4 on the casing of the
controller will indicate four different states, see Table 4-1:
Yellow LED
Off
On
Slowly blink
Rapidly blink
carry
"#"
to
toggle
Alarm Reset?
[#] To Reset
System disarmed
[#] to Arm
System Armed
[#] To Disarm
Table 4-1 States of Indicator Lamp
System Protection State
In protection withdrawal state
In protection setup state
In protection setup delaying state
In protection setup state, and alarm triggered.
out
protection
between protection setup and protection
19
TCP/IP Network Access Controller
setup
or
withdrawal
Advertisement
Table of Contents
