Table of Contents
Advertisement
TCP/IP Network Access Controller
Input times in the start time and end time, select the door entry/exit mode during the time
period and then click the "Apply" button to finish the setting. After setting and changing all
the entry/exit modes, click the "Save" button and click the "Return" button to return the
scheme setting page.
After setting the date time period of the control scheme, click the "Save" button to save the
setting. See the figure below:
Figure 12-10 Update data
After the setting of a certain date is finished, the setting of another date is the same. Select
the set date in the control group scheme setting page, click the "Copy" button to copy the
set date rules, click to select the date on which the rules are applied and click the "Paste"
button in its operation bar, then the rules copy is finished.
12.4 Access Group
Click the "Access Control" "Access Rule," select "Access Group" to enter the control group
setting page; see the figure below:
Figure 12-11 Access group
12.4.1 Add Access Group
In the "Access Group Setting" page, click the "Add" button, then the control group addition
interface pops up.
Figure 12-12 Add control group
88
Advertisement
Table of Contents
