Table of Contents
Advertisement
TCP/IP Network Access Controller
12.2 Door Schedule
Click "Access Control" "Access Rule," select "Door Schedule" to enter the door region
scheme setting page; see the figure below:
Figure 12-3 Delete control group
Left click the "Datesetting" in the selected date type, then the following time period setting
page pops up.
Figure 12-4 Time period setting
Input time in the start time and end time, select the door entry/exit mode during the time
period and then click the "Apply" button.
！ If the authority of multi-card door open is required, please check "Multi-card Door Open"
and select the respective locking level of the four locks in the lock level column. In the
control group setting page, the corresponding unlocking level of the card can be set.
After setting and changing all the entry/exit modes, click the "Save" button and click the
"Return" button to return to the scheme setting page.
After setting the date time period of door region design, click the "Save" button to save the
setting. See the figure below.
85
Advertisement
Table of Contents
