Table of Contents
Advertisement
1.5 Installation Procedures
The Installation has three procedures described as below. Each procedure will be
introduced in the following sections in detail.
Step 1: Installation Preparation
• Obtain a floor plan
• Determine the hardware and location
Step 3: Software Setup / Configuration
• Log in controller built-in software through IE on computer
• Set up user account for user software
• Set up controller and other equipment
• Set holidays, shifts and door access rule
• Log in card and set up card attributes
1.6 Installation Preparation
Before installation, users are advised to collect information properly which will make the
installation more smoothly and helps to reduce time and energy cost. For professional
constructors, the information below will be of great use.
1.6.1 Obtain a Floor Plan
Obtain a floor plan of the building in which the access control system is to be installed.
Obtaining a floor plan helps the installer determine what components need to be installed,
and where. It also is essential in determining the length of cable needed to connect readers
to the controller. A floor plan can be a blue print of the building, a design, or simply a
drawing of the facility. Any document showing the footprint of the building can be used.
The dimensions are important to note, especially when determining cable lengths. A floor
plan may be obtained from your local city hall.
Step 2: Hardware Installation
• Installing the controller
• Connecting to the door lock / open button / sensor / bell
• Connecting the controller to the network
• Connecting to the alarm input / output
4
TCP/IP Network Access Controller
Advertisement
Table of Contents
