Table of Contents
Advertisement
2
Hardware Installation
After the preparation work is finished, user can start installation. This chapter mainly
introduces how to install the hardware part, which is divided into four steps:
1.
Install the controller.
2.
Install the reader and connect the reader to the controller.
3.
Connect the electric strikes or magnetic locks.
4.
Connect the controller to the system computer and reader (optional).
2.1 Installing the Controller
The controller should be installed in an easily-accessible position. However, it should be
noticed that the controller is the core part of the entire system and can be used to change
database. After the installation site is selected, a relative secure clean position in which the
administrator is easy to operate should be selected. In order to facilitate power supply and
communication, a prepared wire chase must be arranged on the periphery of the controller
before installing the controller.
For installing the controller to the desired location, two screws or anchors have to be
prepared.
Wall
Screws
7
TCP/IP Network Access Controller
Chapter
2
Advertisement
Table of Contents
