Changing Of Set Values And Current Values Of T, C And D - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
4.4.2

Changing of set values and current values of T, C and D

Set values and current values of word devices (T, C, D, V and Z) in the PLC can be changed.
u u u u Basic operation
T/C/D monitor
display
Read the values
using the procedure
described in the
previous paragraph.
*1 When the SET key is pressed, the cursor is moved to a current or set value
and the numeric input keyboard is displayed at the bottom of the screen.
Example:
5
0
n n n n Important point
1) Changing of set values of T and C and file registers
They can be changed when a RAM is used as the memory in the PLC.
They cannot be changed when an EPROM or EEPROM cassette is used.
, SET
Move the Change the
cursor to a current value of
device to be D, T and C. *1
changed.
D0 [1000]
Cursor
Numeric (decimal) input keyboard
6 7 8 9
1 2 3 4
0 to 9
Change Enter the Enter a
the set minus (-) numeric.
value of T sign.
and C.
CLR
ENT
HPP Mode 4
ENT
Execute
change.
4-14