Graphic Operation Terminal F940GOT
13.6
Application of screen changeover
This paragraph describes application examples of screen changeover.
13.6.1
Application example 1
In the example below, an abnormality occurs in the machine in the operation mode, an error
message is displayed, then a previous screen is displayed.
Changeover of the base screen
Word device specifying the changeover destination: D0 (initial value)
Screen No. 1
* MONITOR *
CYCLE
OPERATION
CONTINUOUS
OPERATION
"CYCLE
OPERATION" key
Screen No. 2
ONE CYCLE DRIVEN
• When the program shown in the next page is executed while the screen No. 2 or 3 is dis-
played, the screen No. 10 is displayed by the base screen changeover function.
Screen No. 10
ERROR
MOTOR CHECK
"
To the screen No. 2 or 3
• When the previous screen is to be displayed, as shown in this example, use the upper hier-
archy function on a touch key.
• When the CYCLE OPERATION key is pressed, the screen
• To return to the previous screen (screen No. 2 or 3) from the
"
Creation of Display Screens (SW¨ ¨ ¨ ¨ D5C-GOTRE-PACK) 13
It is registered as the common setting for all screens.
No. 2 is displayed. When the CONTINUOUS OPERATION
key is pressed, the screen No. 3 is displayed.
Setting of the screen No. 1
CYCLE OPERATION key
CONTINUOUS OPERATION key: Fixed value = 3
"CONTINUOUS
OPERATION" key
CONTINUOUS DRIVEN
screen No. 10, use the upper hierarchy function of a touch
key.
Setting of the screen No. 10
PREVIOUS key: Upper hierarchy
: Fixed value = 2
Screen No. 3
13-8